Machine inspection
1. Check the water level of the humidification water pan.
2. Check the sealing condition of the door.
3. Check the ventilation and exhaust conditions.
4. Clean up the fluff and other debris on the damper rotating screw to prevent it from getting stuck and rotating.
5. Wipe the outside of the chassis and control cabinet with a semi-dry rag; The hatcher washes the humidifying basin for each batch. and remove the fluff from the top of the machine.
6. Check whether the fan, humidification, and egg turning chain are in good condition.
7. Check the heating function.
8. Check the ultra-high temperature alarm function.
9. Check whether the egg turning function is normal.
10. Clean and disinfect the equipment thoroughly.
11. After each batch of incubation, the machine, humidified water basin and humidified evaporation tray should be cleaned.
Machine maintenance
Weekly maintenance content of the incubator
1. Check the water level of the humidification water tray.
2. Check the sealing condition of the door.
3. Check the ventilation and exhaust conditions.
4. Clean up the fluff and other debris on the damper rotating screw to prevent it from getting stuck and rotating.
5. Wipe the outside of the chassis and control cabinet with a semi-dry rag,The hatcher washes the humidifying basin for each batch. and remove the fluff from the top of the machine.
Monthly maintenance content of the incubator 1. Check whether the fan, humidification, and egg turning chain are in good condition. 2. Check the heating function. 3. Check the ultra-high temperature alarm function. 4. Check whether the egg turning function is normal. 5. Thoroughly clean and disinfect the equipment. 6. After each batch of incubation, the machine, humidified water basin and humidified evaporation tray should be cleaned.
Maintenance of incubation equipment every three months 1. Clean the probe. 2. Calibrate temperature and humidity. 3. Add butter to the fan bearing once. 4. Clean the egg turning worm gear with oil and add butter to lubricate. 5. Butter should be added to the lead screw and sliding fit parts of the damper mechanism. 6. The oil should be changed once for humidification and egg turning reducer. 7. Comprehensively check the control function of each system.
The incubator machine when not in use for a long time before the machine is not used for a long time, the machine must be turned on to heat up the drying machine, the water in the humidified water basin is cleaned and dried, and each running part should be washed and protected with butter to prevent rust. This is very important. If you decide not to use a machine and don't maintain it as described above, the next time you want to use it, it may be out of order.
Precautions
1. Read the manual repeatedly before use.
2. Check whether the fan is turned on and whether water is added to the basin.
3. When stopping the egg turning, check whether the egg turning motor and the program-controlled switch of the egg turning are available.
4. The heater and joints should be firm to prevent scalding of the management personnel.
5. When using the stove home temperature, the water tray should be placed on the top of the insulation layer, if the egg tray on the egg rack is not satisfied, try not to put it near the water tray.
6.Note: When the humidity probe is not in use, it is best to take it out of the incubation room, keep it dry, strictly prevent hanging dew, and it is strictly forbidden to drink the experimental probe by mouth.